Zero Waste Logo The Zero Wate Network the University of Texas at Arlington Center for Environmental Excellence Environmental Training Institute Logo  

Join Us on:

Social Network Nav Bar

Lean and P2 Workshops

Houston
Nov, 14-16, 2017,

Arlington
Dec. 5-7, 2017

 

More...

 

Environmental Management Systems Workshops

Lake Charles
Sep. 26-29, 2017

Arlington
Dec. 12-15, 2017

 

More...

Following are a set of P2 options you may wish to implement. No option is perfect for everyone, but sometimes options that have worked at one facility can work at yours. They might also serve as inspiration.

Reviewed Automotive Services Options

Options below have reviewed by pollution prevention specialists. They are commonly recommended and implemented for facilities.

 
Know where your wastewater goes
Know where your wastewater goes - does the drain lead to a sanitary sewer and a treatment facility, or does the water flow directly to a nearby creek or river? In either case, you want to reduce pollutants, but if you are sending wastewater directly to a river, stream, or lake, you will want to take extra precautions. Direct discharge of wastewater without a permit may be illegal.
 
Keep hazardous waste from sewer
Keep vehicle fluids and other hazardous wastes out of the sewer system. Store them in well-marked containers for recycling or for disposal at an appropriate facility. Be sure not to include them with your garbage unless your hauler recycles them.
 
Prevent spills, leaks, and drips
Prevent spills, leaks, and drips. Keep oil, grease, solvents and other chemicals out of storm and sanitary drains.
  • Use solvents only over self-contained sinks or tanks. Don't allow solvents to drip onto the floor.
  • Prevent leaks in solvent tanks; inspect tanks for leaks and repair any immediately.
  • Keep tanks covered when not in use.
  • Allow cleaned engines and parts to dry over the hot tank.
  • Catch fluid from leaking vehicles in a drip pan, and use drip pans whenever you are changing fluids in a car.
 
Recycle wash water
Recycle wash water from engine and parts cleaning or exterior washing as much as possible.
 
Pretreat steam-cleaning wastewater
Do not allow wastewater from steam-cleaning to flow into storm drains. It must be diverted to the sanitary sewer system with proper pretreatment.
 
Consider plugging shop floor drains
Do you need floor drains? If you are not washing parts or vehicles, or have other uses for the drain, consider plugging the shop floor sewer drains, thereby preventing discharges to sewers.
 
Properly dispose hazardous waste
Recycle motor oil, batteries, solvents, paints, oil filters, antifreeze, and lubricants. Be aware of any materials you use that are considered hazardous substances, and follow all regulations related to their storage, use or disposal.
 
Keep dust and Bondo from sewers
Keep dust from sanding and Bondo out of the sewers by:
  • Sweeping up, not hosing down, dust
  • Allowing debris from wet sanding to dry out overnight before sweeping it up
  • Purchasing sanders with an attached vacuum to reduce clean-up time
  • Disposing non-hazardous dust in the garbage
 
Manage amount of paint used
Use only as much paint and thinner as necessary. Calculate the amount of paint necessary to cover a surface and use the best sized spray cup for the job.
 
Use an enclosed paint gun washer
When you clean the paint spray gun, don't release the wastewater to either the sanitary or storm sewer systems. Use an enclosed "gun washer."
 
Keep batteries off the ground
Keep batteries and chemical containers dry and off the ground to prevent leaks into storm water.
 
Drain fluids from stored vehicles
Drain and collect fluids from stored vehicles that are being dismantled. Reuse or recycle collected fluids.
 
Maintain pretreatment equipment
Inspect, maintain, and clean all pretreatment equipment regularly. Separators and grease traps should be cleaned at least every three months.
 
Dry sweep around fuel-diespensers
Dry sweep areas around fuel-dispensing islands.
 
Use a wastewater recycling system
After pollution prevention techniques, the best way to assure that pollutants stay out of the sewer system is to invest in a self-contained wastewater recycling system. Ultimately, this cuts down water and sewer bills and guarantees that businesses are not contributing water quality problems.

Unreviewed Options, Use with CautionUnreviewed Automotive Services Options

Options below have not been reviewed by pollution prevention specialists. They are commonly recommended and implemented for facilities.

 
Collect and Filter Car Wash Water
Use a car wash system that captures the wastewater (contaminated with detergent and oil/grease) thus keeping it out of the storm sewer by re-directing it to the sanitary sewer. Ensure that the system includes filtration for removal of oil/grease prior to sanitary sewer discharge. Also, use only bio-friendly/green "detergent" for the cleaning operation.
 
Control Chemical Product Inventory
Create a master list of approved chemical products that may be purchased and prohibit the purchase of any chemical products not on the approved chemical product list. Create a procedure employees must go through to get a new product added to the list and be willing to also remove an older product from the list when a new/better product is found/added that will do the same job. This program helps management prevent the use of highly hazardous products, encourage the use of "green" products, and reduce excessive buying of new product when old product is still available for use. Excessive buying of product, caused by each shop employee having his/her own "favorite" and his/her desire to "try the new thing" can create a large volume of waste product annually when product in storage becomes too old or dried out to serve its intended purpose.
 
Secondary Containment for Batteries and Oil
Contain potential spills/releases by use of secondary containment pallets or other secondary containment devices for oil drums, oil filter drums, and battery storage.
 
Manage Chemical Wastes Properly
Package, label, and ship all waste products in accordance with regulations. Choose recycle over disposal whenever recycle is available. Used oil, used oil filters, used antifreeze, used batteries, scrap metal, and used fluorescent bulbs are some of the wastes that can be readily recycled. Ensure that recycle and disposal vendors receiving your wastes are well managed companies that comply with environmental regulations: Check with other facilities using these vendors and/or conduct your own audit. A waste vendor that will not allow you to audit their practices is a waste vendor to avoid.



Find Options for other processes



SHEP Shield
Safety
Health and
Environmental
Professional



ERP Shield
Environmental
Regulatory
Professional



ESP Shield
Environmental
Science
Professional



EMP Shield
Environmental
Management
Professional

Attend a workshop and
earn credits toward a
Professional Certification

 

 



The Zero Waste Network is one of eight Pollution Prevention Resource Exchange P2RxCenters , serving as a national network of regional information centers: NEWMOA (Northeast), WRRC (Southeast), GLRPPR (Great Lakes), ZeroWasteNet (Southwest), P2RIC (Plains), Peaks to Prairies (Mountain), WSPPN (Pacific Southwest), PPRC (Northwest). We are a proud member of the National Pollution Prevention Roundtable.

National P2 Roundtable Logo